Setup and Configuration

Install the hardware support forXilinx^®Zynq^®平台

The embedded target forXilinx Zynq平台enables you to:

Build a Simulink model that loads and runs an executable on theARM^®Cortex^®-A processor embedded in theXilinx Zynq平台.
Use the capabilities and features described inSupported Features for Xilinx Zynq Platform

To get this embedded target, perform the steps described inInstall Support for Xilinx Zynq Platform.

Functions

zynq Display most recent IP address, user name, and password

Build, deploy, and run models on connected hardware boards

Supported Features for Xilinx Zynq Platform
List of supported Features forXilinx Zynq平台
Install Support for Xilinx Zynq Platform
Instructions to install support for Xilinx Zynq platform.
TFTP/WFTPD Configuration Guide
Setup and configure Trivial File Transfer Protocol (TFTP) or Winsock File Transfer Protocol Daemon (WFTPD) to use with your hardware board
Hardware Setup Verification
Description of how theEmbedded Coder^®Support Package for Xilinx Zynq Platformverifies the setup of the Xilinx Zynq hardware board.

To check if theXilinx Zynqplatform is properly configured, repeat the steps in TFTP/WFTPD Configuration Guide.

Configure a Network Interface Card (NIC) on development computer to connect to hardware board.

You can get the IP address of theXilinx Zynqplatform from the MATLAB^®Command Window or using the Linux^®command line.

Open a serial command-line session withXilinx Zynqplatform.

Process to PING anXilinx Zynqplatform connected to your development computer

Generate code from a Simulink® model and run the executable on a Xilinx® Zynq™ platform.

Open Live Script

Generate and run code from a Simulink® model onto a Xilinx® Zynq™ ZC702 evaluation kit with a VxWorks® 7 operating system.

Open Live Script