Send TCP/IP message from server
Simulink Support Package for Arduino Hardware/Ethernet Shield
Send TCP/IP messages from a server over a wired network.
Use this block when your model has the following requirements:
Reliable message transmission
Unchanged message order
Acceptable compromise on the transmission speed
The TCP/IP server created by this block can accept four socket connections on the Arduino board.
This block input accepts uint8 values.
During simulations without the hardware, this block does nothing.
Enter the port number through which you want the TCP/IP server to send the messages. The server port numbers range from 0 to 65535.
ClickView pin mapto open the Arduino Pin Mapping table .
To know how to assign pins for the block, seePin Mapping for Arduino Timer Independent Blocks.