Main Content

Configure Network Settings forArduinoEthernet Shield

You can configure the network settings for the Arduino®Ethernet Shield on the Configuration Parameters dialog box. To do so, selectEthernet Shield properties.

To configure the network settings for the Arduino Ethernet Shield:

  1. Go toConfiguration Parameters>Hardware Implementation>Ethernet shield properties.

    The Arduino board by default gets its IP address through DHCP. Alternatively, you can assign a static IP address to the board by the selecting theUse static IP address and disable DHCP复选框并指定的IP地址。的维efault mode, make sure that the network to which your hardware board connects, supports DHCP for IP address assignment.

    The IP address assignment mode that you select holds good also for the External mode over TCP/IP.

    When your model is deployed to the hardware, you can view the DHCP assigned IP address in the diagnostic viewer below the memory usage information. Alternatively, a MATLAB base workspace variable with the name is created with the value of the IP address.

    When you specify the Ethernet IP address, follow these guidelines:

    • IP address must be in the 4 octet format. For example, 192.168.0.20.

    • When connected to a computer, the IP address of the Arduino Ethernet Shield and the IP address of the computer must be in the same subnet so they can communicate with each other.

      However, make sure they are different.

    • When connected to a router, the IP address must be in the valid range of the supported IP addresses and must not be in the filtered list for that router.

  2. Specify the MAC (Media Access Control) address, the physical network address for the Arduino Ethernet Shield inMAC address.

    When you specify the Ethernet MAC address, follow these guidelines:

    • MAC address must be in the 6 octet format. For example, DE:AD:BE:EF:FE:ED

    • If the Arduino hardware is connected to a router, the MAC address must not be in the filtered list for that router.

Note

DHCP is not supported in External mode for Arduino Leonardo, Arduino Yun boards due to memory constraints.