Acquire and Stimulate Measurements

Perform data acquisition and stimulation on slaves nodes

Functions

`createMeasurementList`	Create measurement list for XCP channel
`viewMeasurementLists`	View configured measurement lists on XCP channel
`freeMeasurementLists`	Remove all measurement lists from XCP channel
`startMeasurement`	Start configured DAQ and STIM lists
`isMeasurementRunning`	Indicate if measurement is active
`readDAQ`	Read scaled samples of specified measurement from DAQ list
`readDAQListData`	Read samples of specified measurement from DAQ list
`writeSTIM`	Write scaled value of specified measurement to STIM list
`writeSTIMListData`	Write to specified measurement
`stopMeasurement`	Stop configured DAQ and STIM lists

Properties

xcp.Channel Properties Properties of thexcp.Channelobject

Topics

Acquire Measurement Data via Dynamic DAQ Lists

This example shows how to can create a dynamic data acquisition list and assign measurements to the list.

Stimulate Measurement Data via Dynamic STIM Lists

This example shows how to can create a dynamic data stimulation list and assign measurements to the list.

Featured Examples

XCP Dynamic DAQ Lists

Use XCP connections to create and use dynamic data acquisition lists. It uses a freely available XCP slave simulator from Vector and Vector virtual CAN channels. For access to virtual channels, Vector device drivers must be installed. It is also recommended to run Vehicle CAN Bus Monitor in conjunction with this example.

Open Script

XCP Direct Data Acquisition

Use XCP connections to directly acquire measurement values from a slave. It uses a freely available XCP slave simulator from Vector and Vector virtual CAN channels. For access to virtual channels, Vector device drivers must be installed. It is also recommended to run Vehicle CAN Bus Monitor in conjunction with this example.