Main Content

Run Model on Target Hardware

Step 4 of 5 in Log Signals on an SD Card

金宝app®deploys code and logs signals on an SD card. These signals are saved as MAT-files on the target hardware.

To deploy the code on the target hardware, on theHardwaretab of the toolstrip, in theModesection, selectRun on board, and then clickBuild, Deploy & Start. The lower left corner of the model window displays status while Simulink prepares, downloads, and runs the model on the target hardware. Wait for the logging to stop.

Note

After theStop timeelapses, the logging of signal stops. However, the model continues to run. For example, if theStop time参数被指定为10.0seconds, the logging stops after 10.0 seconds. However, the model continues to run for an indefinite time. If theStop time参数被指定为Inf, the logging continues until the SD card memory is full, or you remove the SD card from the target hardware.

Log Signals on an SD Card
Next