Feedback and help
This toolkit (2018.03) is still in its early development and testing phase, there are a lot of functions is not perfect.
If you run into problems in use process, or have new ideas, support and help can be obtained through the following way.
Contents
Developer's email as follows:zehan.yu@viewsources.com
We will reply to your feedback and questions as soon as possible.
Group chat
Most of the time, sending emails cannot get reply in time, the efficiency of communication is also relatively low.So you can join the QQ group in order to obtain more quickly and more details of the support and help.
QQ group: bypass analysis technology exchange group
Group no. : 725662287
Qr code: (yes, we are so keep pace with The Times)
making
If you have new requirements in the process of using the toolkit, or there is a problem or error (I believe this will happen not only, and will be very frequent), is the best way to submit an issue on to making.
Submit the issue in the making, often more effective than in QQ group to ask the developer.The reason is that, as a software developer, are likely to teach people how to use the same software, but absolutely will not sit in the software error.
At the same time, making the issue is visible to everyone, and can be retained long enough.In today's problems, you probably half a year later there was another man who will encounter.Or on the contrary, you encounter a problem, after half year ago someone may already met.
If the problem solutions in the first place in the form of a written record down, not only can save a lot of communication cost, also can greatly improve the efficiency of problem solving, more to the benefit of future generations, don't walk again detours.So why not?
However, you may be a bit worried because you didn't even heard of the lot, even heard, never used.No don't worry, as long as simple a few steps, you can submit complete problem.
First of all, submit a lot issue address is:https://github.com/Hansimov/scatool/issues
Then, the point in you will see an interface like this:
If you haven't making account, you can register a (soon), otherwise unable to submit questions.If you see here decided to give up, that also it doesn't matter, lazy lazy people own fortune.
If you already have a lot of account, you can in the above page, click on the right side of the "New Issue", then you will jump to another page.At this point, you can describe your problem:
Click "Submit new issue", and can complete submission of the problem.
But since you have seen here, don't mind to see two words.
A good question, shall provide as much as possible the problem when the environment and details, which is beneficial to developers and other users to better positioning problem.
In addition, before asking questions, it is better to search for, whether to have similar problems, avoid duplication.
Good question, of course, also need to have a lot of other factors, but as long as you follow the above two points, is enough.
Finally, hope the kit can help you.