Documentation

Modeling

Prepare model for hardware connection, add blocks to support hardware protocols

Blocks

Analog Input	Measure voltage of analog input pin
Digital Read	Read logical state of digital input pin
Digital Write	Set logical state of digital output pin
I2C Master Read	Read data from I2C slave device or I2C slave device register
I2C Master Write	Write data to I2C slave device or I2C slave device register
PWM Output	Generate square wave on the specified output pin
SCI Read	Read N-by-1 array of data on UART
SCI Write	Send N-by-1 array of data to UART
SPI Master Transfer	Write data to and read data from SPI slave device
SPI Register Read	Read data from SPI slave device register
SPI Register Write	Write data to registers of SPI slave device
TCP/IP Receive	Receive data over TCP/IP network from remote host
TCP/IP Send	Send data over TCP/IP network to remote host
UDP Receive	Receive UDP packets from UDP host
UDP Send	Send UDP packets to UDP host
Byte Pack	Convert input signals to 8-, 16-, or 32-bit vector
Byte Unpack	Unpack 8-, 16-, or 32-bit input vector to multiple output vectors
Byte Reversal	Reverse little-endian data for big-endian processor
Memory Copy	Copy to and from memory section

Topics

Model Configuration Simulink Coder Support Package for STMicroelectronics Nucleo Boards

Parameter and configuration options for creating and running applications on金宝app^®Coder™ Support Package for STMicroelectronics^®Nucleo Boards

Featured Examples

Getting Started with Simulink Coder Support Package Using STMicroelectronics Nucleo Boards

Getting Started with Simulink Coder Support Package Using STMicroelectronics Nucleo Boards

This example demonstrates how to use the Simulink Coder Support Package for STMicroelectronics Nucleo Boards to run a Simulink® model on an STMicroelectronics Nucleo board.

Open Example

Read Data from I2C-based Sensors Using STMicroelectronics Nucleo Boards

Read Data from I2C-based Sensors Using STMicroelectronics Nucleo Boards

This example shows how to use Simulink® Coder Support Package for configuring and reading data from an I2C-based sensor using an STMicroelectronics Nucleo board.

Communicating with an SPI based EEPROM Using the STMicroelectronics Nucleo Board

Communicating with an SPI based EEPROM Using the STMicroelectronics Nucleo Board

This example shows how to use Simulink® Coder Support Package for STMicroelectronics Nucleo board to enable and write to/ read from an SPI based EEPROM.

Open Example

Change the LED Glow Intensity on STMicroelectronics Nucleo Boards

Change the LED Glow Intensity on STMicroelectronics Nucleo Boards

This example demonstrates how to use the Simulink Coder Support Package to run a Simulink® model on an STMicroelectronics Nucleo board to brighten and dim an LED.

Open Example

Read Accelerometer and Gyrometer Data from an STMicroelectronics Nucleo Board Using SCI Blocks

Read Accelerometer and Gyrometer Data from an STMicroelectronics Nucleo Board Using SCI Blocks

This example shows how to use Simulink® Coder Support Package to send data to your computer from a STMicroelectronics Nucleo board and read it using serial (SCI) blocks.

Simulink Coder Support Package for STMicroelectronics Nucleo Boards Documentation

金宝app

Try MATLAB, Simulink, and Other Products