Data Logging with Simulation Data Inspector (SDI)

This example uses:

Open Script

This example shows how to use a Simulink® Real-Time™ log of signal data and the Simulation Data Inspector. Signals are logged during model execution. At the end of the run, the Simulation Data Inspector interface displays the signal. This example show how to get the signals from the Simulation Data Inspector interface by using the command line.

Open, Build, and Download Model

Open the modelslrt_ex_soc_dist. This model calibrates the control efforts through social distancing on an infectious disease outbreak.

Open the model.

model ='slrt_ex_soc_dist'; mdlOpen = 0; systems = find_system('type','block_diagram');ifall(~strcmp(model, systems)) mdlOpen = 1; open_system(fullfile(matlabroot,'toolbox','slrealtime','examples','slrt_ex_soc_dist.slx'));end

Build the model and download to the target computer:

Configure for a non-Verbose build.
Build and download application.

set_param(model,'RTWVerbose','off'); evalc(“slbuild(模型));

Close the model it is open.

if(mdlOpen) bdclose(model);end

Run Model to Evaluate Effects of No Social Distancing During Outbreak

使用仿真软件实时ob金宝appject variable,tg, load and start the model, and modify model parameters.

tg = slrealtime; load(tg,model); setparam(tg,'','soc_dist_level',1); setparam(tg,'','thresh_int_level',1); start(tg);while~strcmp(tg.status,'stopped') pause(5);endstop(tg);

Update Parameters and Re-evaluate Effect of Social Distancing During Outbreak

使用仿真软件实时ob金宝appject variable,tg, load and start the model, and modify model parameters

tg = slrealtime; load(tg,model); setparam(tg,'','soc_dist_level',0.2); setparam(tg,'','thresh_int_level',0.2); start(tg);while~strcmp(tg.status,'stopped') pause(5);endstop(tg);

Display Signals in Simulation Data Inspector

To view the plotted signal data, open the Simulation Data Inspector.

Simulink.sdi.view

Retrieve and Plot Signal Data from Simulation Data Inspector

You can also retrieve the signal data from the SDI and plot the data by using these commands.

Get all the runs
Get the run information
Get the signal.
Get the signal objects.
Take only infectious group values.
Plot the signals.

The result shows that social distancing can reduce the number of hospitalized people

runIds = Simulink.sdi.getAllRunIDs();fori = 1:length(runIds) run = Simulink.sdi.getRun(runIds(i)); signalID = run.getSignalIDsByName('hospitalized');if~isempty(signalID) signalObj = Simulink.sdi.getSignal(signalID); signalArray(:,i) = signalObj.Values(:,1).Data; timeValues = 100*(signalObj.Values(:,1).Time); plot(timeValues,signalArray); drawnow;endendgridon; xlabel('Time in days'); ylabel('hospitalized people');