Setup and Configuration
Functions
raspberrypi |
Get host name, user name, password, and build directory |
getRunOnBoot |
Get name of Simulink model added to Run-on-boot |
addToRunOnBoot |
Add Simulink model to Run-on-boot |
removeRunOnBoot |
Remove a Simulink model from Run-on-boot |
listAudioDevices |
List available ALSA audio devices |
Topics
Install Support for Raspberry Pi Hardware
Install support Raspberry Pi™ hardware.
Connect Raspberry Pi Zero W to Your Computer over USB
Connect Raspberry Pi Zero W to your computer using a USB cable.
Troubleshooting
Configure Raspberry Pi Hardware to Mail IP Address Changes
Configure the board to send you an email message whenever the IP address changes
Get the Network Settings of the Raspberry Pi Hardware
There are several ways to get the network settings of the Ethernet connector on your Raspberry Pi hardware:
Open a Command-Line Session with Raspberry Pi Hardware
Open a serial command-line session with Raspberry Pi hardware
Configure Network Settings on Raspberry Pi Hardware
Get or set IP address of Raspberry Pi hardware
Access the Linux on Raspberry Pi Using Computer Peripherals
Set up Raspberry Pi hardware as a Linux®desktop or teminal.
Extend the Linux partition on the SD card for Raspbian Wheezy Linux image
Enable Passwordless Sudo on Raspberry Pi Hardware
Run Simulink®models on Raspberry Pi without providing a password.
Shut Down Raspberry Pi Hardware
Shut Down the Raspberry Pi Hardware
Troubleshoot Connecting to Raspberry Pi Hardware(MATLAB Support Package for Raspberry Pi Hardware)
Troubleshoot connecting to Raspberry Pi hardware.
Play High-Quality Audio from Raspberry Pi Using I2S-Based DAC
Enable I2S drivers to output high-quality audio from Raspberry Pi using DAC.